- General
-
Order number D13015 Type code CP-AM-MPRESS Series CP Systems Categories Application module
- Description
-
The application module Muscle press is designed for the pressing of cubic work pieces. The pressing process is carried out by means of a proportional pressure control. The generated force is measured precisely by means of a load cell.
-
Attribute Value Electrical connection 24-pin IEEE 488 female (SysLink)
Analog TerminalPneumatic connection Tube with 4 mm outer diameter Operating voltage 24 VDC Operating pressure 6 bar I/O 2 DI / 3 DO / 2 AI / 1 AO Press force actuation 2x Pneumatic muscle
Maximum allowed force for each muscle: 630 N
Maximum allowed force for station: 100 N per musclePress force measurement Load cell
0 - 200 NPressure regulation Proportional pressure regulator
Pressure range: 0,06 - 6 barDimenions (H x W x D) 525 mm x 240 mm x 185 mm -
Application module interface (Syslink or analog terminal)
Description Reference Datatype Address
CP LabAddress
CP FactoryInputs TRUE = Back cover present +HL-BG1 Bool %I0.0 %I2.0 Current force (0 V = 0 N, 10 V = 200 N) +HL-KF10:12 Word %IW43 %IW6 Current pressure (0 V = 0 bar, 10 V = 6 bar) +HL-KF11:X Word %IW46 %IW8 TRUE = Pressure setpoint reached +HL-KF11:D3 Bool %I0.4 %I2.4 Outputs TRUE = Open emergency stop valve +HL-MB1 Bool %Q0.0 %Q2.0 Set pressure setpoint (0 V = 0 bar, 10 V = 6 bar) +HL-KF11:W+ Word %QW43 %QW6 Regulator behavior bit 0 (0 = selection via display, 1 = fast, 2 = standard, 3 = precise) +HL-KF11:D1 Bool %Q0.4 %Q2.4 Regulator behavior bit 1 (0 = selection via display, 1 = fast, 2 = standard, 3 = precise) +HL-KF11:D2 Bool %Q0.5 %Q2.5 -
-
