Magazine
  • General
  • Order numberD13007
    Type codeCP-AM-MAG
    SeriesCP Systems
    CategoriesApplication module
  • Description

  • The application module Magazine is feeding a carrier with an front cover and a back cover. The carrier is recognized from a light barrier and then stopped. The sensors are checking the condition of the carrier. There are 3 possibilities:

    • There is no workpiece on the carrier.
    • There is a front cover on the carrier.
    • There is a back cover on the carrier.

    According to circumstances and task, a workpiece is isolated from the magazine to the carrier. Afterwards, the carrier is released.

  • AttributeValue
    Electrical connection24-pin IEEE 488 female (SysLink)
    Pneumatic connectionTube with 4 mm outer diameter
    Operating voltage24 VDC
    Operating pressure6 bar
    I/O7 DI / 5 DO
    MagazineStacking magazine
    Capacity: 10
    Dimenions (H x W x D)525 mm x 340 mm x 185 mm
  • Application module interface (Syslink or analog terminal)
    DescriptionReferenceDatatypeAddress
    CP Lab     		Address
    CP Factory
    Inputs
    TRUE = Lift cylinder in upper end position+CL-BG1Bool%I0.0%I2.0
    TRUE = Lift cylinder in lower end position+CL-BG2Bool%I0.1%I2.1
    TRUE = Separator closed+CL-BG3Bool%I0.2%I2.2
    TRUE = Separator open+CL-BG4Bool%I0.3%I2.3
    TRUE = Work piece present in magazine+CL-BG5Bool%I0.4%I2.4
    Magazine front cover: TRUE = pallet present; Magazine back cover: TRUE = front cover present+CL-BG7Bool%I0.6%I2.6
    Magazine front cover: TRUE = front cover already present; Magazine back cover: TRUE = back cover already present+CL-BG8Bool%I0.7%I2.7
    Outputs
    TRUE = Move lift cylinder up+CL-MB1Bool%Q0.0%Q2.0
    TRUE = Move lift cylinder down+CL-MB2Bool%Q0.1%Q2.1
    TRUE = Close separator+CL-MB3Bool%Q0.2%Q2.2
    TRUE = Open separator+CL-MB4Bool%Q0.3%Q2.3
    TRUE = Open lift cylinder end position lock+CL-MB5Bool%Q0.4%Q2.4
    • QR marker
    • QR marker