Labeling
  • General
  • Order numberD13024
    Type codeCP-AM-LABEL
    SeriesCP Systems
    CategoriesApplication module
  • Description

  • The module automatically applies a self-adhesive label that is freely printable to the work piece.
    The print data are individually loaded into the printer in a job-controlled manner. The label is printed immediately before applying the label on the work piece.
    The scope of the Labeling module includes the corresponding control software in the form of program blocks. Program blocks are also provided, which ensure the loading of the print data from MES4.

  • AttributeValue
    Electrical connection24-pin IEEE 488 female (SysLink)
    Ethernet RJ45
    Pneumatic connectionTube with 4 mm outer diameter
    Operating Voltage24 VDC
    Printer operating voltage230 VAC
    Operating pressure6 bar
    I/O6 DI / 7 DO
    Label printerThermo-direct printer
    Programmable label design
    Labelmedia on roll
    Cutter cuts of media after printing
    Dimenions (H x W x D)660 mm x 420 mm x 185 mm
  • Application module interface (Syslink or analog terminal)
    DescriptionReferenceDatatypeAddress
    CP Lab     		Address
    CP Factory
    Inputs
    TRUE = X-axis in label pick-up position+PH-BG1Bool%I0.0%I2.0
    TRUE = X-axis in rear end position+PH-BG2Bool%I0.1%I2.1
    TRUE = Z-axis in upper end position+PH-BG3Bool%I0.2%I2.2
    TRUE = Z-axis in lower end position+PH-BG4Bool%I0.3%I2.3
    TRUE = Work piece present+PH-BG5Bool%I0.4%I2.4
    TRUE = Vacuum created+PH-BP6Bool%I0.5%I2.5
    Outputs
    Move X-axis (FALSE = to rear end position, TRUE = to label pick-up position)+PH-MB1Bool%Q0.0%Q2.0
    TRUE = Move Z-axis up+PH-MB3Bool%Q0.2%Q2.2
    TRUE = Move Z-axis down+PH-MB4Bool%Q0.3%Q2.3
    TRUE = Open Z-axis end position lock+PH-MB5Bool%Q0.4%Q2.4
    TRUE = Switch on vacuum+PH-MB6Bool%Q0.5%Q2.5
    TRUE = Switch on blower+PH-MB7Bool%Q0.6%Q2.6
    TRUE = Switch on label cutter+PH-TM8Bool%Q0.7%Q2.7
    • QR marker
    • QR marker